Hi

Can Receive mail on exchange server 2003 but can't send mail

I nee

Probably better to give a little bit more information of this... Is this a new install or existing? You have posted in an Exchange 2013 forum then stated you have Exchange 2003. What version of Exchange do you have?

If it is 2013 you will have to setup a Send Connector: http://technet.microsoft.com/en-us/library/jj657457(v=exchg.150).aspx

RJ technologies.

My version is 2003

Hi o.k,

Since the issue you came across might be caused by several reasons, we need to do further investigation.

1. The information of your Exchange environment architecture.
2. Have you received any NDR message?
3. Could you send mail in domain? If you can, how about the cross-site mail?

Please reply at your earliest convenience.

Regards,

Rebecca

Below is the message I do receive

Your message did not reach some or all of the intended recipients.

      Subject: testing
      Sent: 9/4/2013 2:47 PM

The following recipient(s) could not be reached:

      yemiolaleye04@yahoo.com on 9/4/2013 2:47 PM
            There was a SMTP communication problem with the recipient's email server.  Please contact your system administrator.
            <literamed.com #5.5.0 smtp;553 Sorry, over your daily relay limit.>

I can send mail locally in the Domain but I can't send mails to people outside the Domain

Hi, are you sending your mail through a smart host? Eg within your SMTP properties relaying across to your ISP?