Hi,

I've tried to setup rules " Apply this rule after the message arrives -> have server reply using a specific message" but it won't reply. (the message is around 300 symbols, so bounce message doesn't work; also Out of office doesn't work because I want to have reply to every email which is arrived)

After few hours research I don't have any idea how to setup this. When I've setup this Outlook says me "Cannot reply to message". If I setup this rule to Exchange 2010, it work properly but on Exchange 2013 doesn't work.

Any suggestions?

Basically I need (Server Side) rule which automatically reply to all messages which arrived in my mailbox :)

• Edited by gyovkov Tuesday, June 02, 2015 8:30 PM

I've not setup transport rule, yet.

I've setup two rules : First is "Apply this rule after the message arrives -> have server reply using a specific message"; and second is "Apply this rule after the message arrives -> reply using a specific template". Both of them work fine with Exchange 2010, but on Exchange 2013 the second one work great, but only when Outlook is running. The first rule shows me error message when I try to run it manually "Cannot reply to message"

For the transport rule I was thinking about bounce message, but it has limitation which not work for me. If you have any other idea please share it.

Thanks

Hi,

Please look at the below link,

https://social.technet.microsoft.com/Forums/en-US/fc92850c-d6f6-4154-a5e4-599dbecd5cbf/how-to-setup-a-autoreply-for-a-supportmycompany-mailbox-?forum=exchangesvrsecuremessaging

maximum 175 character supports

Regards,

Joby

I know this way, but I need more character :)

Is there any other way to configure auto-reply ( Out of office doesn't work for me; mail tip and bounce messages, also doesn't work because they have limit for message)

• Edited by gyovkov 16 hours 6 minutes ago