Installing Exchange 2010 on Server 2008 R2. Getting this "MSExchangeTransport failed to start" error. I did enable IPv6 on the network connection. Nothing in the event viewer jumps out at me. What to do? thanks, Hub Transport Role Failed Error: The following error was generated when "$error.Clear(); if ($RoleStartTransportService) { start-SetupService -ServiceName MSExchangeTransport }" was run: "Service 'MSExchangeTransport' failed to start. Check the event log for possible reasons for the service start failure.". Service 'MSExchangeTransport' failed to start. Check the event log for possible reasons for the service start failure. Elapsed Time: 00:03:01 Finalizing Setup Cancelled

can you post more of the Exchange Setup Log from that installation, I think there will be more clues in there as to what is going on.

Hello before running installition make sure that you make NetTcpPortSharing service is set to automatic and start it and make sure that ipv6 enabled. Thanks MhussainThanks Mhussain

Any update on your issue?Jonas Andersson MCTS: Microsoft Exchange Server 2007/2010 | MCITP: EMA 2007/2010 | MCSE/MCSA Blog: http://www.testlabs.se/blog

that worked. I uninstalled as best I could, made sure ipv6 was checked and the NetTcpPortSharing service was set to automatic. Then did a reinstall. No errors this time.

hi ihave the same problem , and i made sure net.tcp service is on automatic and running and IPV6 is checked but still have the problem i reinstalled twice but nothing changed . Any other solution ? thank you