Sending of Email fail : Client was not authenticated
Hi there,
I have setup Exchange 2010 and is doing a test email to send to server.mydomain.com using the default Administrator account, eg: administrator@server.mydomain.com. However, I got the error saying Client was not authenticated as below. Could anyone advise?
:)
SMTP error from remote mail server after MAIL FROM:<xxx@xxx.com > SIZE=12160:
host server.mydomain.com [xxx.xxx.xx.xx]: 530 5.7.1 Client was not authenticated
Jackson Yap APC Hosting http://www.apc.sg/
October 27th, 2010 2:23am
Is it an internal mail?
Normally I have seen this issue when mails are being sent directly to the Hub transport server, and in that setup you need to allow anonymous access on the receive connector.
/MartinExchange is a passion not just a collaboration software.
Free Windows Admin Tool Kit Click here and download it now
October 27th, 2010 5:07am
Thanks Martin!
I ran these and it works:
First get the receive connector name:
Get-ReceiveConnector
Then use the following command:
Set-ReceiveConnector -Identity “MAILSERVER\Default mailserver” -PermissionGroups “AnonymousUsers”
However although I can receive email to Exchange mailbox, I can't send out, even though I setup a Send connector. Is there anyway I can troubleshoot why mail is not sending out?Jackson Yap APC Hosting http://www.apc.sg/
October 27th, 2010 5:15am
hey!! the sending from Exchange works now!!
I notice you need to specify "*" to enable the sending out of emails in Send Connector.Jackson Yap APC Hosting http://www.apc.sg/
Free Windows Admin Tool Kit Click here and download it now
October 27th, 2010 5:44am