Hi People,

 I'm using MS Exchange Load Generator 2013 and I notice the read/write sizes in Kb is small along with the read/write rate in IOPS. What do I need to do to increase the read/write size and the number of IOPS? I want to really work the Exchange servers I deployed and make them fall over or nearly fall over. I just need to generate a very heavy load.

Does anyone have a config file I can use (excluding any passwords of course) 

Thanks

Mike

• Edited by CoolBeanMike Tuesday, July 28, 2015 7:39 PM

Hi Mike,

Hope the following article can help you with sizing Exchange 2013 Deployments:

http://blogs.technet.com/b/exchange/archive/2013/05/06/ask-the-perf-guy-sizing-exchange-2013-deployments.aspx

Regards,

THANKS!!! Amit... there is not that much out there describing what is what with the tool.

• Marked as answer by CoolBeanMike 17 hours 48 minutes ago

THANKS Satyajit...yup.. I have that running too. wanted to run a full install of Exchange too. 

• Marked as answer by CoolBeanMike 17 hours 48 minutes ago