VERBOSE: Connecting to mailbox.domain.com

I have setup two servers, mailbox and CAS Exchange  2013  in two separate servers where Exchange 2010 is running environment.

When I open a powershell in mailbox server, I get this error. And I can see many warning as well in the mailbox server. but I didin't have any issue during the installation, all done successfully.

What is this error?

New-PSSession : [mailbox.domain.com] Connecting to remote server mailbox.domain.com failed with the

following error message : The client cannot connect to the destination specified in the request. Verify that the

service on the destination is running and is accepting requests. Consult the logs and documentation for the

WS-Management service running on the destination, most commonly IIS or WinRM. If the destination is the WinRM service,

run the following command on the destination to analyze and configure the WinRM service: "winrm quickconfig". For more

information, see the about_Remote_Troubleshooting Help topic.

At line:1 char:1

+ New-PSSession -ConnectionURI "$connectionUri" -ConfigurationName Microsoft.Excha ...

+ ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

    + CategoryInfo          : OpenError: (System.Manageme....RemoteRunspace:RemoteRunspace) [New-PSSession], PSRemotin

   gTransportException

    + FullyQualifiedErrorId : CannotConnect,PSSessionOpenFailed

VERBOSE: Connecting to cas.domain.com.

VERBOSE: Connected to cas.domain.com.

Hello,

Please use winrm quickconfig to check WinRM configuration.

I suggest you use test-servicehealth to check if WinRM service and Exchange RPC Client Access service are started, and other required services.

Hello,

Is there any update?

Sorry for the late reply. I had to work on many different jobs so I put on hold and got it back now to the job.
I have to migrate to exch 2013.

I did as you said in the mbx server and got it like this,

PS C:\Users\administrator.*****> winrm quickconfig
WinRM service is already running on this machine.
WinRM is already set up for remote management on this computer.

If I connect from CAS , it is connecting to the EXCH 2010 - it is like a EXCH 2010 ECP, not the view as EXCH 2013 EAC