I have looked in as many categories as I canand used the 'search' facility...both have proved to beuseless. If I have put this in the wrong area/forum...would someone be good enough to tell me where tolocate/place this request. Using XP, I created a software raid0. I then took out the drive that XP was installed onto and tried to do an install using the raid0. The raid0is listed/availible in the install procedureas 2 seperate drives, not as one, so I would need a driver at the F6 juncture in order for the OS install to see the configuration as a RAID. Are there RAID drivers[MS's own] that will allow me to use the softwareRAID0 as a bootable device and then install XP onto it?...or do I have the wrong idea about this being possible...? thanks, Chris ...anyone have any ideas about this possibility?