Hello,

After I have restarted my DirectAccess Server, DirectAccess stopped working.

If I check Remote Access console I see this errors:

- Configuration for server SRVDA.domain.local cannot be retrieved from the domain controller. 
- IP-HTTPS: Not working properly
- The IP-HTTPS route does not have published propery enabled.
- Route advertisement is disabled on the IP-HTTPS adapter,
- Forwarding is disabled on the IP-HTTPS adapter.

In the Event Viewer I see this error:

Event ID: 10029: IP-HTTPS cannot be enabled on the Remote Access server.

Gpupdate works normally, nslookup also, I can contact DC server from DirectAccess server.

Thank you!

Best wishes,

Marko

Hi Marko,

Thanks for the post.

The first error could happen in one of the following scenarios:

Server has no connectivity to the domain in order to update the policies. Run gpupdate /force on the server to force policy update.

GPO replication might be required in order to retrieve the updated configuration.

This could be because there is no writable domain controller in the Active Directory site of the Remote Access server.

Wait for GPOs to replicate to all domain controllers, and then use Set-DAEntryPointDC to associate the entry point with a writable domain controller in the Active Directory site of the Remote Access servers in the entry point.

Quote from Monitor the configuration distribution status of the Remote Access server.

Also, please check if this thread could help on other errors.

DirectAccess Setup - IP-HTTPS: Not working properly

http://social.technet.microsoft.com/Forums/en-US/winserver8setup/thread/b89c6f66-5970-4c0d-b555-8b7035265f21/

Hope this helps.

Hi Marko,

I would like to check if there is any update.

Thanks.

Hi All,

I faced same issue. I have requested our domain conroller and reboot that particular DC and also create All TCP and UDP port allow on DA server's window firewall. 

Hope your issue will resolve :) 

MK

• Proposed as answer by Mukul K G Friday, December 19, 2014 2:49 PM

Quote "I have requested our domain conroller ". What does that mean? Please be specific.

Also what ports did you open in the Firewall?